[Kyselinka]

Ahojte, nenasiel so podobne vlakno, tak sa opytam tu.
Na mojom HTPC v podpise som presiel z Libreelec verzie 9.2.6 na verziu 10 a potom aj na verziu 11, no ziadna mi nevyhovovala. Tak som sa vratil naspat na verziu 9.2.6, ale prestalo mi fungovat WOL. V biose som nic nemenil, pred tym mi to fungovalo. HTPC prebudzam cez Yatse. Prebudenie cez klavesnicu funguje, len cez siet nie. Skusal som aj cez mobilnu apku Fing a aj cez PC WakeonLAN apku a nic nezabera. Nema niekto napad ako to opat spojazdnit? Je to dost dolezita funkcia pre mna. Vdaka.

Este pridam:

Kód:

HTPC:~ # ethtool eth0
Settings for eth0:
        Supported ports: [ TP MII ]
        Supported link modes:   10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
                                1000baseT/Half 1000baseT/Full
        Supported pause frame use: Symmetric Receive-only
        Supports auto-negotiation: Yes
        Supported FEC modes: Not reported
        Advertised link modes:  10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
                                1000baseT/Half 1000baseT/Full
        Advertised pause frame use: Symmetric Receive-only
        Advertised auto-negotiation: Yes
        Advertised FEC modes: Not reported
        Link partner advertised link modes:  10baseT/Half 10baseT/Full
                                             100baseT/Half 100baseT/Full
                                             1000baseT/Full
        Link partner advertised pause frame use: No
        Link partner advertised auto-negotiation: Yes
        Link partner advertised FEC modes: Not reported
        Speed: 1000Mb/s
        Duplex: Full
        Port: MII
        PHYAD: 0
        Transceiver: internal
        Auto-negotiation: on
        Supports Wake-on: pumbg
        Wake-on: g
        Current message level: 0x00000033 (51)
                               drv probe ifdown ifup
        Link detected: yes